景成发精密五金弹簧(深圳)有限公司-欢迎您访问

yamaha贴片机,二手yamaha贴片机

景成发精密五金弹簧(深圳)有限公司

yamaha贴片机,二手yamaha贴片机
 您当前所在位置:首页 >  新闻中心>>>新闻详情

YAMAHA贴片机常见故障及解决方法?

  • 来源:
     作者:admin      更新时间:2017-8-7 12:10:47      字体:

YAMAHA贴片机常见故障及解决方法
1、PCB传输故障:
① E0070:PCB TRANSFER ERROR
Unexpected PCB is on the Conveyor
PCB传输故障,额外的PCB在运输轨上
意义: 在运输轨上的PCB,数量超过额定的数量。
② E0071:The PCB detected before transfer is not detected after transfer. Maybe there is the PCB on the edge of the moving conveyor . Set the PCB to its normal Position Manually. 传输前检测的PCB在传输后检测不到,可能在移动运输轨的边缘有PCB,用手将PCB放置在其正常的位置。
意义: 载入开始检测的PCB在载入后不能确认,卸出前确认的PCB在出口处检测不到,或载入卸出前不能确认的PCB 在载入卸出后被检测到。

③ E0072:Machine in Unable to start running because the conveyor width is not ready . The conveyor width will be changed first . Misaligment of PUSH-UP PINS or PCB on conveyor may danage machine .
Assure Safety and push the [ENTER] YAMAHA贴片机常见故障及解决方法_文库下载http://www.wenkuxiazai.com/doc/9380d63b376baf1ffc4fad4a.html key.
意义: 因未准备运输轨宽度机器不能开始运行,运输轨宽度将先被改变,在运输轨上的PCB或上推顶针的失调可能损坏机器,确保安全并按[ENTER]键。

④ E0073:PCB is detected on the edge of the moving conveyor. Set the PCB to its normal Position mannally.
在移动运输轨边上检测到PCB,将PCB手动放置在正常位置。
意义:在移动运输轨的的连接部分,危险警告传感器检测到一块PCB。
⑤ E0074:PCB FIXING ERROR
PCB trans-Unit, Locate-Pin or push-up-Unit does not response to command. PCB固定故障
PCB传输部件,定位针或上推部件不响应指令。
意义:在PCB传输部件上的定位针传感器或上推部件,传感器不能正确响应电磁阀的状况。

⑥ E0078: When the PCB was transfered to fixed conveyor of PCB exit Side ,error happened for time over Maybe the PCB stoppered between fix conveyor and moving enveyor or the PCB stopped is fixed
Conveyor of PCB exit side .
Set the PCB to its normal position mannally.


【 推荐阅读 】

【责任编辑】:版权所有:http://localhost/转载请注明出处

您当前的位置:首页 >公司新闻>>深圳yamaha贴片机代理商那家最好吗?

二手yamaha/雅马哈贴片机
用手机扫描二维码关闭
二维码